Variable approach drives savings in Kildare
Ireland's second largest water treatment facility is benefiting from massive savings on its pumping costs - and reduced wear and tear - thanks to the installation of ABB VSDs
Leixlip Water Treatment Plant is saving more than €500,000 a year on its pumping costs thanks to the installation of ABB variable speed drives (VSDs). The Leixlip Water Treatment Works in Co Kildare is the second largest water treatment facility in Ireland. With a capacity of 175,000 m3/d, it supplies over 30% of the drinking water requirements of the Greater Dublin Region, serving Fingal, Kildare and the northern part of Dublin City.
The treatment works has six pumps in two sets of three: one used for duty and the other on standby. In each set of three motors, two were controlled by soft starts and one was controlled by a VSD.
The control method used was to vary the speed of the one pump with the VSD and bring in the others as required. All three motors were running constantly to keep up with demand. The pumps have butterfly valves which were throttled to maintain the required head.
Pat Nolan, plant supervisor for Leixlip, says: “We were prompted to look at our energy use because costs had risen substantially.”
Contractor AECOM and ABB were asked to investigate the pumps’ energy use and come up with a solution to reduce it. The investigation found that the three motors had an absorbed power of 1,690kW, a total made up of two soft start motors drawing 620kW and the VSD driven motor drawing 450kW.
The proposal concluded that major savings could be achieved by opening the valves and employing four more VSDs.
A spokesperson for AECOM says: “We certainly had no objection to using more ABB VSDs. We have been using them for ten years and were happy to continue using the same supplier. The drives have always been very reliable.”
Four 710kW ABB cabinet built drives were installed in place of the existing soft starts and now work in conjunction with the two drives previously installed. Each new drive was installed without any disruption to the plant, maintaining full operation at all times.
Before each drive was installed, the associated motor was sent off-site to be fitted with insulated bearings on the non-drive end to resist the bearing currents generated by the drives and prevent the damage these could cause. It was also necessary to transfer the previous control logic and safety relays from the soft starts to the new VSDs. All this additional work took careful project management to ensure Leixlip was 100 percent operational at all times.
Following installation of the drives, all three motors run at the same speed, providing a flow of 5,700 m3/hr – the balance of the plant’s capacity is routed via other methods, such as gravity feed. The new absorbed power is 1,326kW, a saving of 364kW. With a 24- hour, 365 day operation, this was a saving of 3,179,904kWhrs. With energy costing 0.16c per kWhr, this gives a total saving of €508,784 per year and a payback time of less than a year.
“The savings were very significant and even more than we expected,” says Pat Nolan. “Another benefit was the reduced wear and tear on the discharge valve through using the variable speed system.
John Conboy, drives & motors manager for ABB, says: “The initial control logic at Leixlip made sense when the plant was built, however, with energy costs increasing all the time it is certainly worth investigating further opportunities for efficiency. The savings here are incredible.”
© Faversham House Ltd 2023 edie news articles may be copied or forwarded for individual use only. No other reproduction or distribution is permitted without prior written consent.