Saving energy efficiently
When Severn Trent Water was having flow rate problems at its Wanlip Sewage Treatment Works, the installation of ABB variable speed drives sorted out the problem - and proved a double winner by massively reducing energy costs too.
Energy cost savings of around £100,000 a year are being achieved by Severn Trent Water (STW) thanks to the installation of ABB variable speed drives at its Wanlip Sewage Treatment Works.
The company had been experiencing low flow rates on its dry well flow pumps, with typical rates being less than 400l/s against a design of 550l/s.
This meant that under storm conditions the works was unable to achieve the rates specified under the Environment Agency’s consents, without the need for supplementary temporary pumping, further adding to operating costs.
Sentridge Control, a member of the ABB Drives Alliance, had cured a similar problem at another of STW’s treatment works and was asked to get involved in providing a solution at Wanlip.
Glen Hickman, of Sentridge, says: “We suspected the problem was due to ragging of the pumps and reversed the flow of selected pumps to prove this. Ragging is where rags foul the pump inlet and prevent the pump operating normally.”
The original installation had four direct-on-line pumps and two pumps controlled by variable speed drives (VSDs). One of the VSD driven pumps was a duty pump while the other was used to assist as pumping requirements demanded.
Historically, reversing the pumps had allowed them to achieve higher flow rates for short periods of time.
One of the direct-on-line pumps achieved 550l/s compared with 325l/s previously, while one of the VSD-powered pumps achieved 575l/s, compared to 390l/s.
To solve the problem permanently, Sentridge suggested installing 75kW ABB industrial drives on all the pumps, each equipped with ABB Anti-Jam software, part of its Intelligent Pump Control (IPC) software. An add-on to ABB industrial drives, IPC contains all the common functions needed by water and waste utilities, industrial plants and other pump users.
The Anti-Jam software module performs a number of cleaning cycles every time the pump starts. Each cycle consists of a series of rapid ramp ups in both forward and reverse directions.
Taking one to two minutes to complete, the cleaning cycle removes the debris from around the pump volute, preventing it from entering the pump and blocking it when the pump ramps up from zero to its normal operating speed.
The cleaning cycle is also started when the VSD detects a drop in pump efficiency.
Graham Drabble, STW’s capital liaison technician for Wanlip, says: “As well as curing the flow problem, the new installation allows us to achieve our pumping requirement using only two or three pumps instead of all six, achieving an energy saving of approximately £100,000 per year.” n
© Faversham House Ltd 2022 edie news articles may be copied or forwarded for individual use only. No other reproduction or distribution is permitted without prior written consent.